Your cart is currently empty.
Search Products

Instructions
All installation instructions can be found in the list below or for more instructions you can look under the description in the product's listing page or
PRE and POST Care And Maintenance Instructions
CUSHIONS
Cushions will attach either with Velcro straps, snaps, or a combination of both. Each cushion will come with the female snaps attached however snap locations may vary depending on the year and factory your hull was assembled. In this instance, there are male snaps and screws provided which can be added to the boat. 5200 Marine Adhesive can be used to close old holes and can also be used in lieu of the screws. Snap extenders can also be used in some instances.
To install new snaps on the boat simply lay the cushion in place, lift slightly, mark with a pen or sharpie, and drill a pilot hole using 1/16" drill bit.
Many cushions are vacuum sealed to reduce shipping charges. Follow instructions on this orange card for applying the sealing sticker to the plastic foam covering before use.
WOOD KITS
Pilot hole drill bit: 1/8"
13' and 15' SPORT & 40th ANNIVERSARY EDITION
13' AND 15' SUPER SPORT OR SUPER SPORT DELUXE
16'7" MAHOGANY CENTER CONSOLE
17' MONTAUK/OUTRAGE REVERSIBLE PILOT SEAT
MONTAUK/OUTRAGE FIBERGLASS CENTER CONSOLE
LIGHTING
BOW LIGHT LED BULB REPLACEMENT
RUB RAIL
Videos:
1) Leo Gallant installs a 3 piece kit with pop rivets on his 13'
2) Jamestown Distributors installs rub rail (using screws) and end caps on Outrage
-Pilot hole drill bit: 7/32"
3) For an installation photo album click here (you will need to log in to WhalerCentral.com)
BIMINI TOP
STAINLESS RAILS
Pilot hole drill bit: 1/8"
WOOD LOCATION DIAGRAMS (requires Continuous Wave account)
13' SIDE RAILS (multiple instructions based on interior shown in listing)